|
|
Post by Fletch on Jun 10, 2015 18:56:23 GMT -5
Need two 1/16 scale webers for a tooned project I would like to try.
|
|
|
|
Post by grandpamcgurk on Jun 11, 2015 6:15:13 GMT -5
Not sure what scale - either 1/16 or 1/8. The ones I measured were 1/2" long x 5/8" tall by 3/16' thick for a tooned project I would like to try. Fletch, maybe, just maybe......(that is if I can find 'em). The one's I have are 3-D printed (TDR Innovations) in the older material. They are 1/8th, and will require some sanding & finishing. I'll look around later this afternoon, check the size, post a pic or let you know I can't find them. |
|
|
|
Post by grandpamcgurk on Jun 14, 2015 7:54:15 GMT -5
Fletch, here's a couple "close up" shots of the printed (side draft) Webers I have, they are 1/8th scale and may be a little too large for what you need. They measure: 5/8" tall without the velocity stacks, 7/8" with stacks. 3/8" wide & about 7/8" long. Lots of detail but like I said they are printed in the older material and will need a little clean up and a couple coats of primer or CA to smooth them out. I have 3 of them, let me know if you want 'em.    |
|
|
|
Post by Fletch on Jun 14, 2015 8:29:50 GMT -5
Hey GrandpaMcGurk, Thanks for going to all that trouble. Unfortunately those are way too big. Bummer. So now I know I need 1/16 scale. Guess I have to keep looking. Thanks again, Fletch |
|
|
|
Post by grandpamcgurk on Jun 14, 2015 9:39:17 GMT -5
I do believe that's the scale you are looking Fletch, these are 1/16th from a MPC Cobra kit......they measure out at the dimensions you had in your post.........guess what? I've got a set of 4 (used).
|
|
|
|
Post by grandpamcgurk on Jun 14, 2015 9:41:28 GMT -5
Forgot to add pic.  |
|
|
|
Post by Fletch on Jun 14, 2015 9:59:24 GMT -5
Yea - those look like the ones I need for my project. I will PM you for details.
|
|
|
|
Post by grandpamcgurk on Jun 14, 2015 10:31:15 GMT -5
Details sent.
|
|
